User manual FLYMO EASICUT 500CT

[. . . ] Never use the product unless the guards provided by the manufacturer are in the correct position. Read the user instructions carefully to make sure you understand all the controls and what they do. Do not operate in the rain or leave the product outdoors while raining. The use of eye protection is recommended to protect against objects thrown by the cutting parts. [. . . ] Always ensure the hand guard supplied is fitted before using the product. Never attempt to use an incomplete product or one with an unauthorised modification. Never operate the product with damaged guards or without guards in place. Whilst using the product always be sure of a safe and secure operating position. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Remove the Battery Pack :before leaving the product unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition; if the product starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the blade cover provided. If over a period of time the battery quickly runs down after a full 5-6 hour charging period, a replacement battery is needed. There will be some charge present in the battery but to ensure maximum running time, recharge your product for 5-6 hours before use. Contact your local approved service centre/dealer/distributor for a replacement battery and for safe disposal of your old battery. Plug the charger (B1) into a suitable household electrical wall socket and switch on. Re-charge the battery as soon as the cutting power of your product begins to die and slow down. Charging the battery according to these instructions should ensure maximum battery life. Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. bATTERY DISPOSAL · The battery should be taken to an Authorised Service Centre or your local Recycling Station. Lead/Acid batteries can be harmful and should be disposed of through the recognised recycling facility in accordance with European Regulations. [. . . ] * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades. Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way Genom att se till att denna produkt omhändertas ordentligt kan du hjälpa till att motverka potentiella negativa konsekvenser på miljö och människor, vilka annars kan orsakas genom oriktig avfallshantering av denna produkt. Batteriet skall lämnas in till en godkänd servicedepå eller till Din lokala återvinningsstation. Odsluzen akumulator morate odpeljati na Pooblasceni center za servis ali pa v lokalni center za recikliranje. [. . . ]