User manual FLYMO VISIMO VM032 PLUS

[. . . ] Never operate the product with damaged guards or without guards in place. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Do not tilt product when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. [. . . ] Installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower. Keep cable away from product, always work away from the power point mowing up and down, never in circles. Always switch off at the mains before disconnecting any plug, cable connector or extension cable. Switch off, remove plug from mains and examine electric Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. T ensure you have a secure connection between the o lawnmower and the extension cable we strongly recommend you use the following method of attaching the cable: 1. Plug the short connection lead into the socket of the extension cable. Form a loop in the end of the extension cable near to the socket and secure this in the strain relief feature at the top of the switchbox. The Motor is protected by a Thermal Cut-Out which is activated when the blade becomes jammed or if the motor is overloaded. The Thermal Cut-Out will only reset when the start/stop lever is released. Clear any obstruction and wait for a few minutes for the Thermal CutOut to reset before continuing to use the mower. Switch off, wait until the blade has stopped rotating and disconnect from the mains electricity supply BEFORE attempting to remove or refit the blade. To remove the blade bolt, hold the blade firmly with a gloved hand and with a spanner, loosen the blade bolt by turning it anti-clockwise (R). In the event of a blade becoming difficult to remove, insert a screwdriver (S1) into the hole (S2) to lock the drive, then use a spanner to loosen the blade bolt by turning the spanner anti-clockwise. Ensure the screwdriver is removed before atempting to turn on the machine. Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. Fit the blade to the shaft with the sharp edges of the blade pointing away from the shaft. Hold the blade firmly with a gloved hand and tighten the blade bolt firmly with a spanner . [. . . ] Does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna UK Ltd. Your product is uniquely identified by a silver and black product rating label. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 09), 2004/108/EC, 2000/14/EC based on the following EU harmonized standards applied: EN60335-1, EN60335-2-77, EN836, EN50366, EN55014-1, EN61000-3-2, EN61000-3-3 The maximum A weighted sound pressure level LpA at the operators position, recorded on a sample of the above product(s) corresponds to the Level given in the table. [. . . ]