User manual HUMAX F2-FINDER

[. . . ] Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GB2 Warning & Glossary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GB3 Reference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GB4 ~ GB5 STB Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Today's day of the week is displayed on the last item of the list. · Schedule & Information Press to display the schedules for the day of the week you have selected on the Category window. The name of the programme is displayed on the right of the window. · Operation Press the OK button to display reservations and detailed information about the service you have selected on the Schedule & Information window. Press the EXIT button to exit this window. GB22 To reserve a programme you want: 1. Select a programme you want to reserve by using the P+/Pbuttons in Schedule & Information window. Then, a clock icon ( ) will be displayed to the left to the reserve time, which indicate the reserve was registered successfully. Select a programme you want to cancel reservation by using the P+/P- buttons in Schedule & Information window. You can view that the selected programme is added as a cancel item on the Operation window of the pop-up window. Move the cursor to the Operation window using the button and select Cancel, and then press the OK button. To view the detailed information about a programme on Schedule & Information window: 1. Select a programme you want by using the P+/P- buttons in Schedule & Information window. buttons and then press the GB23 Main Menu Guide Simple EPG (TV/Radio) Shows a Simple EPG like an Information box. Time range of bar : This consists of three blocks by 30 minutes per block. Reserved EPG Shows the programme lists that you have already reserved on the TV EPG ( or Radio EPG) or Information box. This programme list includes service name, date, duration time, reservation mode and event name. To cancel a reservation, follow the same steps given in the "To cancel reservation for a reserved programme" section for the Advanced EPG mode. 3. Channel Search Enter the PIN code to access the Channel Searching menu as you access the Parental Control menu. Press the OK button to start Service Search after setting the parameters. Antenna Setting Selects the antenna and LNB settings for Service search. As you can change the settings for 22KHz Tone and DiSEqC switch, there are 32 possible Antenna Setting for use. The values that are set in this menu will be available for selection in other channel searching menus. GB24 Antenna Alternative There are 32 antenna alternatives, each one can have different combinations of settings for 22KHz Tone and DiSEqC switch. Satellite Name Selects the Satellite Name that corresponds to the value of the Antenna Alternative. If the desired Satellite Name is not listed then select User Defined and OK button. [. . . ] If multiple locations are found, you should select other frequency and drive the motor again until only a single location is found. You can select Stop at the best location by using the signal level and signal quality bar on the bottom of the window and then move the cursor to Operation window and select Store the item to save the current location information. Be careful that if you exit the menu without saving this location information, the current Satellite location information will be lost. Repeat the above steps for other Satellites to use your Motorised System for them. [. . . ]