User manual JENSEN UV9

[. . . ] We hope you will find the instructions in this owner's manual clear and easy to follow. If you take a few minutes to look through it, you'll learn how to use all the features of your new Jensen Phase Linear UV9 Mobile Multimedia Receiver for maximum enjoyment. Congratulations on your purchase of the Jensen Phase Linear UV9 Mobile Multimedia Receiver. It's a good idea to read all of the instructions before beginning the installation. [. . . ] When shifting into DRIVE gear, the TFT monitor is retracted back inside unit. Choose a source for which you would like to increase the relative volume (LEVEL). After entering calibration mode, a crosshair appears in a corner quadrant of the screen. To begin calibration, press and hold the crosshair for one second until it moves to the next quadrant. When the ignition is turned OFF, the TFT panel DOES NOT retract if it was previously out Touch the top left corner of the screen (the RADIO circle) to view the SOURCE MENU. Touch the BAND button (15) on the screen, or press the BAND button on the remote control (18) to change between the following bands: FM1, FM2, FM3, AM1, and AM2. Touch the preset number in which you would like to store the current station (or touch Exit to cancel and close the menu). Current radio band indicator Radio frequency indicator Clock Stereo broadcasting indicator Strong Local signal broadcasting indicator Preset radio stations: Touch to recall preset stations Information about the current function Touch for quick access to Equalizer level settings Touch to access the direct entry screen Current preset station indicator |<<: Touch to seek backward >>|: Touch to seek forward <<: Touch to tune backward one step >>: Touch to tune forward one step BAND: Touch to change between AM/FM bands AS: Touch to automatically store stations Touch to view the SOURCE MENU and select a new playback source 18. PS (Preview Scan): Touch to scan all stations available, stopping for 5 seconds at each and continuing until a station is selected To enter a radio station directly, touch the button or press the GOTO button (19) on the remote control to display the direct entry menu. Auto Store (AS) To select six strong stations and store them in the current band: 1. Press the AS button (3) on the control panel or touch AS (16) on the screen for 2 seconds to activate the Auto Store function. Preview Scan (PS) To scan the AM or FM band for a preview of available stations in your particular area, touch the PS button (20). When the Local function is on, only radio stations with a strong local radio signal are played. to activate the Local function in AM/FM tuner mode , press and hold the rotary encoder button (11) on the front panel. NOTE: When properly installed, DVD video cannot be displayed on the main TFT screen unless the parking brake is applied. If you attempt to play a DVD while the vehicle is moving, the TFT screen displays "PARKING" with a blue background. To access the on-screen controls, touch the bottom 1/3 of the screen while a DVD is playing. Touch the 1/2 button to view a second page of controls · NOTE: For VCD play, the repeat function is not available if PBC is on. Closing the TFT Screen Press the OPEN button (1) again to close the TFT screen. Press the REPT A-B button again once you reach the desired end point (B) of the repeated section. Press the REPT A-B button again to cancel the A-B section setting and stop repeat play. Slow Motion Playback Press the << button (20) on the remote control or the << button on the screen to play the current title in slow motion. [. . . ] Press EJECT key for 5 seconds to reset loading mechanism vehicle to reach a normal temperature before using player. When the vehicle warms up during cold weather or under damp conditions, condensation may appear on the LCD panel. Should this occur, the screen will not operate properly until the moisture has evaporated. We suggest you use a cleaning disc in this unit more frequently than in the unit in your home due to the environmental conditions of the vehicle. [. . . ]