User manual JENSEN VOYAGER MCD5070

[. . . ] Consult with your nearest dealer if installation requires the drilling of holes or other modifications to your vehicle. Install the unit where it does not interfere with driving and cannot injure passengers if there is a sudden or emergency stop. [. . . ] (When re-attaching the frame, point the side with a groove downwards and reattach. ) Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Important Notes DIN Front/Rear Mount This unit can be property installed with either a "Front" (conventional DIN front mount) or "Rear" (DIN rear mount installation, utilizing threaded screw holes at the sides of the unit chassis) mount. Remove the detachable front panel, if it is Dashboard attached to the chassis, by pushing the Bend Tabs REL button. Slide the mounting sleeve off of the chassis if it has not already been removed. 53 If it is locked into position, use the removal Screw Stud keys (supplied) to disengage it. The removal keys are depicted in "Removing the Unit" on page 3. Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Check that there will be sufficient space behind the dashboard for the radio chassis. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Dashboard 2. Removal Key Trim Plate Installation Push the trim plate against the chassis until it is fitted. [. . . ] If the error code does not disappear, consult your nearest service dealer. If the error code does not disappear, consult your nearest service dealer. Disc cannot be loaded or ejected Presence of CD disc inside the player Inserting the disc in reverse direction Compact disc is extremely dirty or disc is defective Temperature inside the vehicle is too high Condensation Volume is too low Wiring is not properly connected. The operation keys do not work Control panel not properly installed The built-in microcomputer is not operating properly due to noise Sound skips The installation angle is more than 30 degrees. [. . . ]