User manual JENSEN VOYAGER MSR3007

[. . . ] For more reliable playback, please adhere to the following recommendations: · Use CD-RWs with speed 1x to 4x and write with speed 1x to 2x. Be sure to use only round CDs for this unit and do not use any special shape CDs. Do not use CDs with labels or stickers attached or that have sticky residue from removed stickers. NOTE: A disc may become scratched (although not enough to make it unusable) depending on how you handle it and other conditions in the usage environment. [. . . ] If removal keys are inserted at an angle, they will not lock properly to release the unit. Chassis Ground Connect to ground terminal or clean unpainted metal part of chassis. Press AS/PS again to stop scanning when the desired station is reached. Press the BAND button (16) to change between three FM bands and two AM (MW) bands. Press and hold the TUNE/TRK >>| or |<< buttons (20, 21) to automatically seek the next or previous strong station. Press and hold the AS/PS (15) button for more than three seconds to automatically select six strong stations and store them in the current band. nOTE: During Auto Store (AS) , the tuner will default to "Local" mode while scanning the band initially. After scanning the entire band once, the unit will switch to "Distant" mode for all subsequent Auto Store tuning. Insert a disc, label-side up, into the disc slot (24) with the unit turned on. The unit will automatically draw the disc in and play the first track on the disc. Press and hold the TUNE/TRK >>| or |<< button to fast forward or fast reverse through the disc. Previewing Tracks Press the 2/INT button (6) to play the first 10 seconds of each track sequentially. Press 2/INT again to stop Intro Scan and resume normal play at the current track. Repeat Play Press the 3/RPT button (5) during disc play to repeat play the current track. Random Play Press the 4/RDM button (7) during disc play to play all tracks on a CD in random, shuffled order. The preset buttons (5-10) can be used to store 6 channels, allowing convenient access to your favorite channels. Press and hold a preset button (5-10) until the corresponding preset button number appears. Press the TUNE/TRK |<< / >>| buttons (20/21) to move between the three digits. The Sirius ID number will scroll twice and then freeze with the first 11 digits on the display. While in the category mode, press the CAT - /+ buttons again to view category names. [. . . ] This is a result of the radio being placed close to the ignition system (engine). This type of noise can be easily detected because it will vary in intensity of pitch with the speed of the engine. Usually, the ignition noise can be suppressed considerably by using a radio suppression type high voltage ignition wire and suppressor resistor in the ignition system. (Most vessels employ this wire and resistor but it may be necessary to check them for correct operation. [. . . ]