User manual KYOCERA FS-3820N

[. . . ] FS-3820N FS-3830N Page Printers Operation Guide Caution on Installation No liability is assumed for any damage caused by improper installation. Notice on Software Software used with this printer must support the printer's emulation mode. The emulation mode can be changed by following the procedures described in Chapter 1. Notice on This Guide The information in this guide is subject to change without notification. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. No responsibility is assumed if accidents occur while the user is following the instructions in this guide. [. . . ] or key repeatedly until >e-MPS Configuration > >e-MPS > Configuration 5 6 Press the > key. Code JOB Size 050MB 7 To change the maximum disk space, press the ENTER key. Code JOB Size 050MB 1-71 e-MPS 8 Press the or key to increase or decrease, respectively, the value at the blinking cursor. Use the > and < keys to move the cursor right and left. 9 When the desired size is displayed, press the ENTER key. The message display returns to Ready. Maximum Space Assigned to Permanent Code Jobs This changes the Microdrive space that holds permanent code jobs. The actual maximum size depends on the size of free Microdrive space, however. Press the or key repeatedly until e-MPS > appears. e-MPS > Press the > key. or key repeatedly until >e-MPS Configuration > >e-MPS > Configuration 5 6 Press the > key. Code JOB Size 050MB Press the or key to increase or decrease, respectively, the value at the blinking cursor. Use the > and < keys to move the cursor right and left. 1-72 e-MPS 9 When the desired size is displayed, press the ENTER key. The message display returns to Ready. Maximum Space Assigned to Virtual Mailboxes This changes the Microdrive space for virtual mailboxes. The actual maximum size depends on the size of free Microdrive space, however. Press the or key repeatedly until e-MPS > appears. e-MPS > Press the > key. or key repeatedly until >e-MPS Configuration > >e-MPS > Configuration 5 6 7 8 Press the > key. Press the or key repeatedly until >>VMB Size appears. >>VMB Size 050MB Press the ENTER key. A blinking cursor ( ) appears. >>VMB Size 050MB Press the or key to increase or decrease, respectively, the value at the blinking cursor. Use the > and < keys to move the cursor right and left. 9 When the desired size is displayed, press the ENTER key. The message display returns to Ready. 1-73 Interface Interface This printer is equipped with a parallel interface, a USB interface and a network interface. An optional serial interface and a second network interface can be installed as well. Various printing environment parameters such as the default emulation can be changed indepently on different interfaces by using the printer's menu selection system. Before select the interface to apply the changes in the procedure described below. This interface selection described below does not select which interface data will be received from. [. . . ] The default setting is Off. KM-NET VIEWER This is a network management tool that can be used with the Kyocera Mita FS series. You can view information for printers connected to the network using SNMP commands. KM-NET VIEWER is contained on the CD-ROM supplied with the printer. Emulation This refers to emulation of manufacturers' printers. The printer emulates operation of the following printers: PCL, Line printer, IBM Proprinter, DIABLO 630, EPSON LQ-850, KPDL. MB (mega byte) This unit is used to express data quantities and memory capacities. [. . . ]