User manual MAGELLAN GPS 2000

[. . . ] Press the NAV button to get the status screen which will indicate the signal strength. The PLOT screen is a mini map that shows where you have traveled and where you want to travel. You can view the active route, your current position, the other waypoints, and yourdestination on the PLOT screen. [. . . ] Press the NAV button to get the Plot screen >Press MENU button>Select track hist and press enter>Use Up/Down arrow key to change fields and press enter. Press the NAV button to get the Plot screen >Press Menu button>Select Clr track and press enter>Use Up/Down arrow key to change fields and press enter. While using the SPEED screen, you can view the graphical speedometer, odometer, and trip odometer as well as the numerical bearing, course over ground, and speed over ground. Press the NAV button to get the speed screen >Press Menu button>Select ODOM reset and press enter>Use Up/Down arrow key to select Yes/No and press enter. Press the NAV button to get the speed screen >Press Menu button>Select Trip reset and press enter>Use Up/Down arrow key to select Yes/No and press enter. You can create a waypoint with a receivergenerated name (WPT001, WPT002, and WPTxxx) by pressing the MARK button twice. Press Mark button> Use Up/Down to select data field and press enter>Use the arrow keys to change the name and press enter and press MARK. A GOTO route can be created by selecting a waypoint on the plotter screen. From the plot screen press the MENU button>Select PAN-NSCAN and press enter>Move the crosshair using the arrow keys>Press GOTO>Use Up/Down to select Yes or No and press ENTER Reset the unit by clearing the memory. You say my GPS 2000/320should work up to 15 hours on two batteries, but why doesn't mine last that long? If the batteries are removed for 20 minutes or more, the receiver will lose the time and date. the receiver will collect time and date soon after tracking a satellite. The most common cause is that you are trying to enter coordinates that are in degrees/minutes while your receiver is set to Degrees/minutes/seconds. Because the last two digits in degrees/ minutes are in hundredths (00-99) and degrees/minutes/seconds can be no higher than 59 (00-59), inputting a number higher than 59 while in deg/min/sec results in an error and the receiver does not accept the entry. The first, and most common reason is that you have the display backlight on. the light increases the drain on the batteries causing the decrease in battery life. As mentioned, while your receiver will operate on NiCad batteries, the battery life is diminished. When doing NMEA output with the GPS 2000/320, what should be the map datum on the unit? [. . . ] When doing NMEA output with the GPS 2000/320, what should be the map datum on the unit?What software enhancements and fixes are done after doing version 315?Fixes problems with displaying user waypoint information during pan-n-scan mode. [. . . ]