User manual MIELE SCOUT RX1

[. . . ] 45 Finish vacuuming: if vacuuming started from somewhere in the room . 59 33 en - Warning and Safety instructions This robot vacuum cleaner complies with current safety require‐ ments. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the robot vacuum cleaner, please read these instructions carefully before using it for the first time. [. . . ] You can switch the robot vacuum cleaner into standby before 60 sec‐ onds is up by pressing the Power but‐ ton again. The robot vacuum cleaner is reactiva‐ ted by pressing any button on the re‐ mote control or one of the two sensors in the robot vacuum cleaner display. Selecting the vacuuming mode  Press the Power button on the remo‐ te control. Option 1 (Remote control)  Press the button for the vacuuming mode you want. Spot 46 en  To start vacuuming, press the   but‐ ton on the remote control or the   sensor in the display. Option 2 (Display) The Timer  and the hour indicators will flash in the display. ΁€ Press the  sensor repeatedly until the symbol for the vacuuming mode you want lights up. ΁€ Press the + or - direction button to set the hour you want. ΁€ To start vacuuming, press the   but‐ ton on the remote control or the   sensor in the display. Setting the timer (only possible if the clock has been set) If you would like the robot vacuum cleaner to start at the same time every day, you can save the start time and vacuuming mode you want to memory. Howev‐ er, please be aware that vacuuming may be less thorough. The camera needs light to enable it to navigate with‐ out restriction. ΁€ Press the + or - direction button to set the minutes you want. The Timer  and the minutes indica‐ tors will flash in the display. ΁€ On the remote control, press the but‐ ton for the vacuuming mode you want or the direction buttons until the symbol for the vacuuming mode you want flashes. The robot vacuum cleaner will now start to vacuum at the same time each day. The Timer indicator  lights up to show that the timer has been activa‐ ted. Deactivating the timer  Press the OK button on the remote control for at least three seconds. Reducing the maximum crossing over height The robot vacuum cleaner is set as standard so that it can negotiate a height of up to 20 mm. 6 mm) in order to pro‐ tect chair or table legs, or lamps for ex‐ ample, you can deactivate the factory default setting. Activating the timer / displaying a set start time  Press the Timer button on the remote control briefly. The Timer indicator  lights up, the set start time is shown briefly and the robot vacuum cleaner will start vacuuming at the set start time. [. . . ] Problem F1 Cause and remedy "Wheel raised"  Place the robot vacuum cleaner on a level floor surface. This fault message will also ap‐ pear if the side brushes are not fitted. "Dust box"  Replace the dust box in the robot vacuum cleaner, making sure it clicks into position. "Drive wheels overloaded"  Check whether the drive wheels have become dir‐ ty. [. . . ]