User manual PIONEER AVIC-8DVD

[. . . ] Always observe safe driving rules and follow all existing traffic regulations. € This manual explains how to install this DVD Navigation Unit in your vehicle. Operation of this DVD Navigation Unit is explained in the separate “Operation Manual” or “Hardware Manual” that also came with this unit. 14 - Installation notes - Parts supplied - CAUTION - If you install with the left and right sides of the DVD Navigation Unit parallel to your vehicle’s forward / backward direction DIN Front/Rear-mount . [. . . ] This lead must be connected to the power supply side of the handbrake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. Ground side Handbrake switch 9 ENG/MASTER 96 10 CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 11 ENGLISH This product Note: Cords for this product and those for other products may be different colours even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. power cord Black , Orange/white , Red , Yellow ESPAÑOL  See Page 11. DEUTSCH Yellow/black When combining this navigation unit with a Pioneer car stereo, if the car stereo has yellow/black leads, connect them to those leads. In this way, when the guidance audio is output and when you operate the system by voice, the vehicle stereo is automatically muted to reduce the vehicle stereo volume. Purple/white (REVERSEGEAR SIGNAL INPUT) This is connected so that the navigation system can detect whether the vehicle is moving forwards or backwards. Connect the purple/white lead to the lead whose voltage changes when the reverse gear is engaged. Unless connected, the sensor may not detect your vehicle travelling forward/backward properly, and thus the position of your vehicle detected by the sensor may be misaligned from the actual position. Note: When you use the ND-PG1 speed pulse generator (sold separately), please make sure to connect it. € Do not install the main unit on the board covering the spare tyre or other places which are subject to vibration. € When the main unit is installed under a front seat, ensure that it does not obstruct the sliding action of the seat. Strong mechanical shock to the main unit would increase the errors in location display. € Avoid installing the main unit in places where it will interfere with loading and unloading of the spare tyre, jack, tools, etc. € Check that a disc or a PC card can be ejected with the main unit installed. € Install the main unit on a surface within +30 degrees to -15 degrees tolerance (within five degrees to the left or right of your vehicle’s direction of travel). A surface tilted more than this would increase the errors in location display. 5° ESPAÑOL DEUTSCH FRANÇAIS 5° 30° 15° • Do not install the main unit vertically. ) Frame 15 ENG/MASTER 96 16 CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 17 CAUTION • Install with the left and right sides of the DVD Navigation Unit perpendicular or parallel to your vehicle’s direction of travel. Do not install diagonally to your vehicle’s direction of travel or the current location will be displayed incorrectly. € If you install the left and right sides of the DVD Navigation Unit parallel to your vehicle’s direction of travel, switch the installation direction lever, and attach the locking screw to the “↔” side, or else the G sensor mounted in the DVD Navigation Unit will not operate correctly. [. . . ] If this unit is loose, it disturbs driving stability, which may result in a traffic accident. € Do not attach this unit to the outer circumference of the steering wheel. Always attach this unit to the inner circumference of the steering wheel as shown. 22 23 ENG/MASTER 96 CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 24 Installation Remote control handling notes • Always keep the remote control protected from direct sunlight or high temperatures. [. . . ]