User manual RYOBI POWER KIT: 650W IMPACT DRILL EID650FK

[. . . ] Use of a cord suitable for outdoor use reduces the risk of electric shock. f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. Important! It is essential that you read the instructions in this manual before operating this machine. [. . . ] g) Use the power tool, accessories and tool bits etc. , in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ¡ö Protect your lungs. If using an extension lead, ensure that the male and female plug connection is elevated and out of the way of any water contact. ¡ö OPERATION The bit can be removed by reversing the above procedure. SWITCHES (Fig. 3) APPLICATION stainless steel and pipe may also be drilled. Mark the point to be drilled with a nail or a punch before drilling. DRILLING IN CONCRETE (Fig. 9) WARNING: This impact drill is designed for light consumer use. It is NOT designed for trade or industrial use and is not covered by the guarantee for use in these applications. Your drill starts and stops by squeezing and releasing the trigger switch. For continuous operation, press the lock on button while the trigger switch is fully depressed. To release the lock, squeeze the trigger switch again. FORWARD REVERSE SWITCH (Fig. 4) SPECIFICATIONS Power input: No load speed: Blows per minute: Chuck capacity: Drill capacity: 650 W 0-2, 800 min 0-28, 000 b/min 13 mm Steel: 13 mm Masonry: 13 mm Wood: 25 mm 2. 00 kg -1 Your drill is fitted with a forward reverse lever which allows the removal of screws. ¡ö FORWARD ROTATION: Situate the lever in the "R" (right) position indicated on your drill. ¡ö REVERSE ROTATION: Situate the lever in the "L" (left) position indicated on your drill. VARIABLE SPEED (Fig. 5) Rock and masonry are generally drilled in hammer mode. When drilling delicate material such as wall tiles, it is essential to start with ordinary drilling and once the tile is pierced, to continue with hammer drilling. In deep boreholes the drill bit should be pulled out occassionally in order to remove the dust and chips from the hole. They must be open at all times for proper motor cooling. MAINTENANCE ¡ö ¡ö Your drill has a variable speed control mechanism designed to allow the operator to have control and adjustment of speed and torque limits. [. . . ] WARNING: The chuck and exposed metal surfaces of the tool may become "live" if the tool drills into wiring in a wall. The operator must always ensure that the area being drilled does not conceal electrical wiring or plumbing. Do not make any adjustment while the motor is in motion. Always disconnect the electrical cord from the power source before changing the drill bit, brushes, or when working on the unit. [. . . ]