User manual RYOBI POWER KIT: 900W ANGLE GRINDER EAG900FK

[. . . ] EAG900FK ANGLE GRINDER OWNER'S OPERATING MANUAL 8 N197 DESCRIPTION DESCRIPTION WHEEL GUARD Components list 1. Lock nut spanner SPINDLE SPINDLE COLLAR SCREW BACKING FLANGE GRINDING WHEEL CUT OFF WHEEL GUARD BACKING FLANGE DRY DIAMOND WHEEL LOCK NUT Fig. 3 SPINDLE 2 3 BACKING PAD SANDING DISC LOCK NUT 1 WIRE BRUSH Fig. 1 Please refer to pages 3 - 4 for instructions GENERAL POWER TOOL SAFETY WARNINGS WARNING Read all safety warnings and all instructions. [. . . ] Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. b) The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of wheel is exposed towards the operator. The guard helps to protect operator from broken wheel fragments and accidental contact with wheel. Abrasive cut-off wheels are intended for peripheral grinding, side forces applied to these wheels may cause them to shatter. d) Always use undamaged wheel flanges that are of correct size and shape for your selected wheel. Proper wheel flanges support the wheel thus reducing the possibility of wheel breakage. langes for cut-off wheels may be different from grinding wheel flanges. Wheel intended for larger power tool is not suitable for the higher speed of a smaller tool and may burst. Additional Safety Warnings Specific for Abrasive Cutting-Off Operations: a) Do not "jam" the cut-off wheel or apply excessive pressure. b) If the use of a guard is recommended for wrie brushing, do not allow any interference of the wire wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and centrifugal forces. ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ALWAYS USE PROPER GUARD WITH GRINDING WHEEL. When using grinding wheel attachments, the guard must always be attached to the tool and positioned for maximum safety, so the least amount of wheel is exposed from the side the tool is being operated. Face shield or at least safety goggles, dust mask, leather gloves and shop apron capable of stopping small wheel or workpiece fragments. POSITION THE CORD CLEAR OF THE SPINNING GRINDING WHEEL OR ANY OTHER SANDING ACCESSORY. If you lose control and have the cord wrapped around your arm or wrist it may entrap you and cause injury. AVOID BOUNCING AND SNAGGING THE WHEEL, ESPECIALLY WHEN WORKING CORNERS, SHARP EDGES ETC. When grinding is resumed the proper guard and wheel flanges MUST be reinstalled before proceeding with grinding. The guard must always be attached to the tool and positioned for maximum safety, so the least amount of wheel is exposed from the side the tool is being operated. The grinding wheel guard cannot be used for most sanding operations or for wire brushing. WHEN SANDING CHEMICALLY PRESSURE TREATED LUMBER, PAINT THAT MAY BE LEAD BASED, OR ANY OTHER MATERIALS THAT MAY CONTAIN CARCINOGENS, USE SPECIAL PRECAUTIONS. A suitable breathing respirator must be worn by all personnel entering the work area. Work area should be sealed by plastic sheeting and persons not protected should be kept out until work area is thoroughly cleaned. [. . . ] ¡ö To turn the tool "ON" without locking it, push and slide the switch button forward by applying pressure ONLY at the REAR portion of the button. When pressure is released the switch button will snap to "OFF" position. ¡ö To lock the switch "ON", slide the switch button forward and press "IN" the FRONT portion. ¡ö To unlock the switch, simply press and release the REAR portion of the button. [. . . ]