User manual SMEG CVB20RR1

[. . . ] 28 3. 1 Choice of location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 3. 2 Positioning and leveling the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 3. 3 Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ARRANGING FOODS IN THE FREEZER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Smeg cannot be held liable for any damage incurred as a result of incorrect use of the appliance. The freezer has undergone the necessary leakage tests for the coolant loop and meets the safety requirements applicable to electrical appliances. Attention: The manufacturer cannot be held liable for any personal injury or property damage caused by failure to observe the above requirements or by tampering with any part of the appliance or using non-original spare parts. 24 Instructions for the Installer 3. INSTALLATION AND CONNECTION 3. 1 Choice of location Always locate the freezer in a dry, sufficiently ventilated area. Ensure that it is not directly exposed to the sun's rays and do not locate it outside. Depending on the climate class to which it belongs (indicated on the nameplate inside the freezer), the appliance can be used in various temperature conditions: Class SN (Subnormal) N (Normal) ST (Subtropical) T (Tropical) Room temperature from + 10°C to + 32°C from + 16°C to + 32°C from + 18°C to + 38°C from + 18°C to + 43°C Do not locate the freezer near a heat source. If this is unavoidable, in order to prevent the proper operation of the product from being compromised, a suitable insulation board must be used. Otherwise, locate the appliance at least 3 cm away from electrical or gas cookers and at least 30 cm away from combustion heaters or radiators. To ensure that the condenser cools properly, the freezer must not be located too close to the wall. To avoid this, the product is equipped with two plastic spacers (1) which must be placed on the upper part of the condenser. If the freezer is installed under a wall unit, the two must be at least 5 cm apart. The red light (2) will come on to indicate that the function has been activated and the alarm (3) will stop. Once the freezing temperature has been reached, the red light (2) will go out. When the red light goes out, press the button (1) again to turn off the "Rapid freeze" function. - Note It generally takes approximately 24 hours to reach freezing temperature. The surrounding temperature, the frequency with which the door is opened and the location of the appliance can affect the internal temperature of the freezer and therefore the amount of time required to reach freezing temperature. Attention: When freezing temperature is reached, the "Rapid freeze" function must be turned off in order to avoid unnecessary electricity consumption. Note Reopening the freezer door immediately after closing it may be difficult. Please wait 2 or 3 minutes to enable the low pressure which has formed to be compensated for. 6. 2 Adjustment and selection of the cooling temperature The selector located at the top of the freezer and visible when the door is open is used to adjust the cooling temperature inside the freezer. Position · corresponds to turning off the freezer (the appliance is still supplied with electricity but the green light will be off). There is no direct correspondence between the setting chosen and the temperature inside the freezer. By selecting a higher number on the control, the temperature in the freezer will be lowered. Only select the highest settings (3-4) if they are really necessary: the freezer will consume more electricity at these settings. [. . . ] Then turn the selector to setting · and remove the plug from the electric socket (or turn off the master switch). Open the door and remove the deep-frozen products from the drawers, protecting them from defrosting during the cleaning phase. Place a container (2) (not supplied) under the drain to catch the water from the defrosting. Turn the freezer back on using the selector on the control panel. 34 Instructions for the User 8. 2 Cleaning the freezer Before cleaning, remove the plug from the electric socket (or turn off the master switch). [. . . ]