User manual SMEG DRY8SSA

[. . . ] Do not touch discharging hose and water during discharging as the appliance may reach high temperatures when running. In case of any breakdown, unplug the appliance firstly and then turn the water faucet off. Remember that packaging materials of your machine may be dangerous for children. Keep the packaging materials in a place where children cannot reach or dispose of them as to wasting instructions. [. . . ] If the lamp above the function button is flashing it means you cannot use that additional function for the wash programme you selected. Reason for non-activation: -The auxiliary function you want to use in the washing programme you have selected is not applicable. -Your machine has passed over the stage, during which the auxiliary function you like to select would be implemented. -It is not compatible with an auxiliary function you have selected previously. 21 CHAPTER 6: OPERATING YOUR MACHINE Half-load detection system Your machine features a half-load detection system. In case you put approximately half or less amount of laundries of maximum laundry capacity in your machine, your machine will run so as to save washing time, water consumption and energy in some programmes (White cotton 95°, Colorfast cotton 60°, Non colorfast cotton 40°). When halfload function is active, the machine can complete the programme you have set in a shorter time. 22 CHAPTER 6: OPERATING YOUR MACHINE PROGRAM TABLE PROGRAMME TEMPERATURE (°C) DETERGENT COMPARTMENT MAXIMUM AMOUNT OF DRY LAUNDRY (kg) 5 5 5 3 2 2 5 5 2 3 3 3 3 2 LAUNDRY TYPE 1- COTTON 2- COTTON 3- COTTON 4-SYNTHETICS 5-SILK 6-WOOL 7-RINSE 8-SPIN 9-HAND W ASH 10-SPORTS WEAR 11-MIX WASH 12-SHIRTS/ BLOUSES 13-BABY WEAR 14-DAILY 60 min. 95 60 40 60 30 40 30 30 30 60 50 60 2 2 2 2 2 2 2 2 2 2 2 2 Very dirty cotton and flax textiles. (Underwears, linen, tablecloth, towel (maximum 2, 5 kg), bedclothes, etc. (Underwears, linen, tablecloth, towel (maximum 2, 5 kg), bedclothes, etc. (Underwears, linen, tablecloth, towel (maximum 2, 5 kg), bedclothes, etc. (Nylon socks, shirts, blouses, synthetic-including trousers etc. ) Less dirty silk-mixed laundries with machine wash labels. If you want to additionally rinse your laundries upon completion of washing operation, you may use this programme for any kind of laundries. When any of the programmes is running and child lock is active, if another programme is selected after programme knob is switched to 0 position, the programme already running will resume. To deactivate it, it will be sufficient to press on the same buttons for more than 5 seconds. When child lock is deactivated, child lock light on the electronic display will go off. 28 CHAPTER 6: OPERATING YOUR MACHINE CANCELLING PROGRAMME Cancelling programme If you want to cancel any programme running: - Switch the programme knob to 0. - Your machine will stop the washing operation and the programme will be cancelled. - To get rid of the water accumulated in the machine switch the programme knob to any programme. - Your machine will perform the necessary discharge operation and cancel the programme. - You can run your machine by selecting a new programme. 29 CHAPTER 6: OPERATING YOUR MACHINE FINISHING PROGRAMME Finishing programme - Your machine will stop by itself as soon as the programme you have selected finishes. -Expression of “END” will flash on the electronic display. - Leave the door of your machine open to allow the inner part of your machine to dry after removing your laundries. - Turn the water faucet off. 30 CHAPTER -7: WARNING SYMBOLS WARNING OF WATER CUT-OFF / LOW MAINS WATER PRESSURE If symbol flashes on the control panel: - Water faucet may be closed. You can select a programme and run your machine after the mains water is supplied. (*) (*) See the chapter regarding maintenance and cleaning of your machine. 31 CHAPTER -7: WARNING SYMBOLS WARNING OF CLOGGED PUMP FILTER If symbol flashes on the control panel: - Pump filter may be clogged. [. . . ] (*) See the chapter regarding maintenance and cleaning of your machine. 40 CHAPTER -10: TROUBLESHOOTING FAULT POSSIBLE CAUSE Discharging hose clogged or twisted. Do not put laundries Your machine more than the Your machine overloaded with amount vibrates. laundries or recommended and laundries settled settle the laundries in non-homogeneously the machine homogeneously. (*) See the chapter regarding maintenance and cleaning of your machine. [. . . ]