User manual SMEG KITG20BQ

[. . . ] THE MANUFACTURER DECLINES ALL LIABILITY FOR IMPROPER USES OTHER THAN THOSE STATED ABOVE. This kit, for separate sale, has been specially designed to convert the barbecue from LPG to NATURAL GAS. It contains all the components and instructions necessary for the conversion procedure. [. . . ] If the appliance has been mounted on the optional trolley, lock the wheels using the clamps provided. Any pulling or tension on the hose might reduce the appliance's safety level. 10 Instructions for the Installer BURNER, NOZZLE AND GAS CONSUMPTION DATA TABLES Burner Rated heat capacity (kW) Bottled gas – G30/G31 30/37 mbar n. turns Nozzle By-pass Reduced Capacity Capacity by-pass diameter 1/100 heat g/h G30 g/h G31 1/100 mm capacity (W) mm closed 100 2200 85 327 321 closed closed 1 + 1/4 1 + 1/4 closed 100 100 95 105 94 Left Central (BQ90T) Right Radiant grill Radiant grill (BQ90T) Ultrarapid (BQ6030T) 4. 5 4. 5 4. 5 3. 8 4. 5 3. 5 85 85 Adj. 65 2200 2200 2500 2700 1500 327 327 276 327 254 321 321 271 321 250 In the by-pass n. of turns column, closed means fully screwed down. Burner Rated heat capacity (kW) Natural gas - G20 20 mbar n. turns by-pass Nozzle diameter Reduced heat 1/100 mm capacity (W) 150 2200 150 2200 150 2200 145 2500 155 2700 133 1500 Left Central (BQ90T) Right Radiant grill Radiant grill (BQ90T) Ultrarapid (BQ6030T) 4. 5 4. 5 4. 5 3. 8 4. 5 3. 5 1 + 1/4 1 + 1/4 1 + 1/4 2 2 + 1/2 1 11 Instructions for the Installer CHANGING THE NOZZLES REPLACING THE BURNER SECTION NOZZLES 1 Remove the grids and refractory plates inside the barbecue section. 4 Using a 7 mm socket wrench, undo the nozzles on the taps (replace the nozzles as specified in the table above). 5 Adjust the primary air flows (see adjusting primary air flows section). 6 Put the burners back into place correctly and tighten the fixing screws. REPLACING THE RADIANT GRILL NOZZLES (ON TOP VERSIONS ONLY) 1 Remove the rear of the barbecue by undoing the supporting screws. [. . . ] Check that the flame remains stable when the knob is turned quickly from the maximum to the minimum setting. If the minimum flame is not even, remove the knob and make small clockwise or anti-clockwise adjustments to the bypass then check stability again. [. . . ]