User manual SMEG KSA900HX

[. . . ] Call the authorised Service Centre. Printed in Italy 03/13 The control panel is switched off, the appliance does not work. The appliance could be in On/Standby mode. Door alarm active It is activated when the refrigerator compartment door remains open for a prolonged period of time. There is water on the bottom of the refrigerator compartment. The front edge of the appliance, at the door striker seal, is hot This is not a defect. Malfunction alarm The alarm indicates a fault in a technical component. Read the instructions carefully before using the appliance. [. . . ] Lighting type 2) To remove the light bulb, turn anticlockwise as shown in the figure. Wait for 5 minutes before reconnecting the appliance. 2 1 Lighting type 3) If the product has LED lighting which is in need of replacing, contact the After-Sales Service for assistance. LED lights last longer than normal bulbs, they illuminate better and are more environmentally friendly 10 WHEN THE APPLIANCE IS NOT IN USE Unplug the appliance from the mains, then empty, defrost (if necessary) and clean it. Leave the doors ajar, so that air can circulate inside the compartments. This will prevent the formation of mould and bad odours. DURING BLACKOUTS Keep the doors closed to allow the stored food to stay cold as long as possible. If the blackout persists, the blackout alarm may sound (depending on the model). REFRIGERATOR COMPARTMENT The refrigerator compartment is designed for the storage of fresh food and beverages. Droplets of water on the rear wall of the compartment indicate that the periodic automatic defrost cycle is in progress. The defrost water is automatically routed to a drain outlet and into a container from which it evaporates. Depending on the model, the appliance may have a special box (“Meat & Fish” or “Zero Degrees”) which is ideal for the storage of fresh meat and fish. Important: refrigerator accessories must not be washed in a dishwasher. Note: the ambient temperature, the door opening frequency and the position of the appliance may affect temperatures inside the two compartments. To work out if the temperature inside the Meat & Fish box is correct, refer to the pictures below: When the arm points to the left, you need to raise the temperature in the refrigerator compartment. When the arm is in the middle, the temperature is ok. When the arm points to the right, you need to lower the temperature in the refrigerator compartment. Important: when the function is activated and foods with a high water content are present, condensation may form on the shelves. In this case, disable the function temporarily. To ensure correct operation of the product, adequate preservation of food and to optimise energy consumption, it is advisable not to remove the Meat & Fish compartment if the symbol (see Quick Guide) is not present on the control panel. In all other cases, the Meat & Fish compartment can be removed to obtain more space inside the refrigerator. Remove the drawer cover by releasing the bottom side clips (Figure 2). To reinstate the Meat & Fish compartment, make sure to refit the drawer cover before inserting the drawer and reactivating operation. Press the “Meat & Fish compartment function” button on the control panel for 3 seconds, until the yellow indicator goes off. To optimise energy consumption, it is advisable to deactivate the Meat & Fish compartment and remove its components (except the shelf above the crisper drawers). Removing the Meat & Fish compartment: Fig. 2 13 “ZERO DEGREES” BOX (depending on the model) The “Zero Degrees” box is specifically designed to maintain a low temperature and a suitable humidity level, in order to keep foods fresher for longer (e. g. meat, fish, fruit and winter vegetables). Activating and deactivating the box The temperature inside the box, when active, is approximately 0°. To activate the compartment, press the button shown in the figure for more than 1 second, until the symbol lights up The symbol lit indicates that the compartment is functioning. To restore “Zero Degrees” box operation, make sure you replace the white plastic shelf underneath the box before inserting the drawer and reactivating the function. [. . . ] Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact After-sales Service for further instruction. [. . . ]