User manual SMEG ML60

[. . . ] 22 USE OF THE SINK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance INSTRUCTIONS FOR THE INSTALLER: these instructions are intended for the qualified technician who must perform the installation, put it into operation and test the appliance 15 Instructions for safety and use 1. [. . . ] Fix the tap in place by inserting the mounting flange (7) and the hold-down nut (8); check that the tap is in the correct position in relation to the sink and tighten the nut using a suitable spanner or similar tool. • • 2 4 6 5 7 8 1 17 Instructions for the installer 2. 2 Installation diagram for sink parts RECTANGULAR OVERFLOW 18 Instructions for the installer 2. 3 • • • • Overflow drain The installation provides the option of connecting the flexible tube to the overflow drain control. Insert the end of the tube (1) into the pin (2) on the drain control (3). Check that it is functioning correctly by filling the sink with water and turning the handle at the front. 5 4 5 2 3 1 19 Instructions for the installer 3. POSITIONING 3. 1 Built-in installation FRONT VIEW SIDE VIEW POSSIBLE HOLE FOR REAR WATER CONNECTION WATER CONNECTION TUBE 1/2” f POSSIBLE HOLE FOR WATER CONNECTION IF THERE IS A BACK WALL POSSIBLE HOLE FOR LOWER WATER CONNECTION WATER DRAIN GAP WATER DRAIN GAP 20 Instructions for the installer 3. 2 Installation on a trolley See the instructions provided with the trolley to install the sink like a normal barbecue. 3. 3 Connection to the water distribution network Connect the water intake connector on the back (A) to a water connector with a 1/2” female threaded end, taking care to screw them onto the tube tightly. If the water tube is new or has been unused for a long period, feed water through it before connecting it up to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water intake will get blocked and damage the appliance. 21 Instructions for the installer 4. WATER DRAIN The water drainage can be connected up in three different ways depending on requirements and the location of the sink. The drain can be connected: • to a tank-type container • for dispersion into the environment • to the network. 4. 1 To a tank In this case, a quick coupler joint is required for the drain. A tube with a suitable diameter should then be connected up and inserted into the coupler, locking it with a clamp or similar part. To ensure that the tube does not detach accidentally and spill water into the surrounding area, make sure that it is securely attached to the drain connector. Similarly, check that the tube is inserted properly into the tank. 4. 2 For dispersion away from the sink The connection is the same time as the one used for the tank. It is important to establish in advance where you wish to direct the drainage water. [. . . ] Rinse the sink carefully and dry with a soft cloth or a chamois leather. 25 Instructions for the user 7. 2 Inspection and cleaning of the drain 1 2 3 4 If the outflow of water in the sink is not continuous, the drain needs to be cleaned (1). Place a container underneath the drain to catch the water once the drain tube has been detached (2). [. . . ]