User manual SMEG RI360RX

[. . . ] • When you move the appliance, lift it by the front edge to avoid scratching the floor. SAFETY INSTRUCTIONS Installation WARNING!• Follow the installation instruction supplied with the appliance. • Wait at least 4 hours before connecting the appliance to the power supply. • Do not install the appliance close to radiators or cookers, oven or hobs. [. . . ] The function switches off by selecting a different set temperature. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes. The door open alarm conditions are indicated by: 22 Fan function 1. To switch off the function, repeat the procedure until the Fan indicator goes off. The activation of the Fan function increases energy consumption. If the function is activated automatically the Fan indicator is not shown (refer to "Daily use"). DAILY USE WARNING!Refer to Safety chapters. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. Gradually pull the shelf in the direction of the arrows until it comes free. Reposition as required. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. Low Temperature compartment In models equipped with this feature in the fridge part, it is intended for a best conservation of fresh foods like fish, meat, seafood, etc. It is located in the lower part, directly above of the vegetable conservation drawer. Temperature indicator For proper storage of food the refrigerator is equipped with the temperature indicator. The symbol on the side wall of the appliance indicates the coldest area in the refrigerator. If OK is displayed (A), put fresh food into area indicated by symbol, if not (B), adjust 23 the temperature controller to a colder setting and wait 12 hours before checking the temperature indicator again. A recovering after door opening or when the ambient temperature is high. OK OK After putting fresh food into the appliance or after opening the door repeatedly or for a long period, it is normal for the indicator not to show OK; wait at least 12 hours before readjusting the temperature controller. B It is possible to switch on the device manually when needed (refer to "Fan function"). The Fan device stops when the door is open and restarts immediately after the door closing. Fan The refrigerator compartment is equipped with a device that allows for rapid cooling of foods and more uniform temperature in the compartment. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Periodic cleaning CAUTION!Do not pull, move or damage any pipes and/or cables inside the cabinet. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Clean the inside and accessories with lukewarm water and some neutral soap. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. Leave the door/doors open to prevent unpleasant smells. 25 WARNING!If you want to keep the appliance switched on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Refer to Safety chapters. What to do if. . . Problem The appliance does not operate. [. . . ] With the door open, loosen the two screws situated in the lower part without unscrewing them completely. 4. Position the steel compensator as indicated in the figure and insert the upper part under the head of the screws. 5. Align the compensator with the steel door panel and tighten the screws. Do a final check to make sure that: • All screws are tightened. 4. Insert the steel carter inside the compensator as indicated in the figure. 30 TECHNICAL DATA Technical data Dimensions of the recess Height Width Depth Voltage Frequency mm mm mm Volts Hz 1780 560 550 230-240 50 The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENT CONCERNS Please recycle all materials marked with the symbol . [. . . ]