User manual SMEG S232XC-1

[. . . ] Cleaning and user maintenance shall not be made by children without supervision. WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e. g. [. . . ] Never wash them while they are still warm and never use abrasive powders. Do not allow vinegar, coffee, milk, salted water, lemon or tomato juice from remaining in contact with the enamelled surfaces for long periods of time. WARNINGS: - correctly preserve the plate after use by treating it with special products, easily available on the market. - After use, pour a little lukewarm oil on the plate and wipe it with a cloth. Never cook food directly on the electric plates but always in a pot or container. 6 Installation and maintenance must only be carried out by a qualified installer. The appliance must be correctly installed in conformity with current law and the manufacturer's instructions. Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. INSTALLATION 4) INSTALLING THE HOT PLATE Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts. In case of doubt, do not use the appliance and contact qualified personnel. Never leave the packaging materials (cardboard, bags, polystyrene foam, nails, etc. ) within children's reach since they could become potential sources of danger. The measurements of the opening made in the top of the modular cabinet and into which the hot plate will be installed are indicated in either fig. 3, comply with the measurements given for the hole into which the appliance will be recessed (see fig. If a wood is installed above the hob, please look at the hood manufacturer instructions regarding the minimum distance between hood and hob (fig. 4). - detach the seals from their backing, checking that the transparent protection still adheres to the seal itself. 5) under the edge of the hob itself, so that the outer part of the seal itself perfectly matches the outer perimetral edge of the hob. - Evenly and securely fix the seal to the hob, pressing it in place with the fingers and remove the strip of protective paper from the seal and set the plate into the hole made in the cabinet. Ensure the tag fits into the hole “H” on the hotplate base, then tighten the screw “F” until it is locked to the worktop (fig. - Since the casing of the hob may overheat due to a prolonged use, it is necessary to insert a separation plane wood, blocked by screws, which must be installed under the cooktop at a minimum distance of 70 mm from the top, as shown in fig. 3. [. . . ] RATING 230 - 240 V~ 50/60 Hz 3500 W WARNING: MAINTENANCE MUST ONLY BE PERFORMED BY AUTHORISED PERSONS. 10 This appliance, before leaving the factory, has been carefully tested and regulated by expert and specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. For this reason, always contact your Dealer or your nearest After Sales Centre whenever repairs or adjustments are required, specifying the type of fault and the model of appliance in your possession. [. . . ]