User manual SMEG S7147LS2P

[. . . ] • Always be careful when you move the appliance because it is heavy. • Wait at least 4 hours before connecting the appliance to the power supply. • Do not install the appliance close to radiators or cookers, oven or hobs. [. . . ] Turn the Temperature regulator toward higher settings to obtain the maximum coldness. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. FIRST USE Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE WARNING!Refer to Safety chapters. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. Gradually pull the shelf in the direction of the arrows until it comes free. Reposition as required. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. 17 If “OK” is displayed (A), put fresh food into area indicated by symbol, if not (B), adjust the temperature controller to a colder setting and wait 12 hours before checking the temperature indicator again. A OK OK After putting fresh food into the appliance or after opening the door repeatedly or for a long period, it is normal for the indicator not to show "OK"; wait at least 12 hours before readjusting the temperature controller. B Do not move the glass shelf above the vegetable drawer and the bottle shelf to ensure correct air circulation. Temperature indicator For proper storage of food the refrigerator is equipped with the temperature indicator. The symbol on the side wall of the appliance indicates the coldest area in the refrigerator. HINTS AND TIPS Normal operating sounds The following sounds are normal during operation: • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). • A faint click noise from the temperature regulator when the compressor switches on or off. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Hints for fresh food refrigeration To obtain the best performance: • do not store warm food or evaporating liquids in the refrigerator • do cover or wrap the food, particularly if it has a strong flavour • position food so that air can circulate freely around it Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the Hints for refrigeration Useful hints: • Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. • For safety, store in this way only one or two days at the most. 18 • Cooked foods, cold dishes, etc. • Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. • Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. • Bottles: these need a cap and should be stored on the door bottle shelf, or (if equipped) on the bottle rack. • Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. CARE AND CLEANING WARNING!If accessible, clean the condenser and the compressor at the back of the appliance with a brush. [. . . ] 200 cm2 22 Electrical connection • Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. [. . . ]