User manual SMEG SF112U

[. . . ] Do not store or use gasoline or other flammable vapors, liquids or materials near this or any other appliance. NOTE: This appliance is NOT designed for installation in manufactured (mobile) homes or in recreational vehicles (RVs). WARNING To reduce the risk of fire, electrical shock, personal injury or damage when using the appliance, follow basic safety precautions, including the following: • Read all instructions • Proper installation is your responsibility. Have a qualified technician install and ground this appliance in accordance with these installation instructions. [. . . ] How to read the user manual This user manual uses the following reading conventions: Installation Information for the qualified technician: installation, operation and inspection. • Stand-alone instruction. SAVE THESE INSTRUCTIONS 5 EN Installation 1 Installation 1. 1 General installation instructions • Proper installation is your responsibility. It is the responsibility of the installer to comply with installation guidelines specified on the model/serial ID plate. The model/serial ID can be found on the internal frame of the oven when the door is opened. • Have your oven installed and properly grounded by a qualified installer, in accordance with these installation instructions. Grounding is mandatory according to the provisions of the electrical system safety regulations. If this appliance is connected to an outside electrical power source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance with the national ANSI/NFPA 70 code of electrical regulations. • Make sure that the voltage and dimensions of the supply line correspond to the information indicated on the model/serial rating plate. A multi-pole circuit breaker must be available on the supply line with contact gap equal to or greater than 3mm, located in an easily accessible position near the appliance. • Do not attempt to repair or replace any part of your oven unless specifically recommended in this manual. To prepare the connection between the oven and the junction box: • Disconnect the power supply to the junction box. • Feed the flexible cable conduit from the oven through the opening of the cabinet. • Install a UL-listed or CSA-approved conduit connector to the junction box. • Route the flexible cable conduit from the oven to the junction box through a ULlisted or CSA-approved conduit connector. IMPORTANT: Any local codes or ordinances should be give priority over these instructions. If used in the new branch circuit installation (1996 NEC) or if local codes do not permit grounding through neutral wire, open the connection and use the grounding wire to the ground unit in compliance with local codes. Connect the neutral wire to the branch circuit’s neutral conductor in the usual manner: • Disconnect the ground from the neutral at the free end of the conduit. • Connect the neutral terminal or wire to the branch circuit neutral in the usual. manner. 1. 3 Electrical connection Warning Electrical shock hazard • Disconnect power to the junction box before connecting. • Electrically ground the appliance with green or green-yellow wire. [. . . ] Fixed connection Fit the power line with an multi-pole circuit breaker in compliance with installation regulations. The circuit breaker should be located near the appliance and in an easily reachable position. Make sure that the cables (for the oven and/or cooktop) follow the best route in order to avoid any contact with the appliance. 1. 5 Positioning Heavy appliance Danger of crushing injuries • Position the appliance into the cabinet cutout with the help of a second person. Pressure on the open door Risk of damages to the appliance • When positioning the appliance during installation, do not use the door handle to lift or move this appliance. [. . . ]