User manual SMEG SLV127EL

[. . . ] Children should be supervised to ensure that they do not play with the appliance. CHAPTER -1: BEFORE USING THE APPLIANCE (CORRECT USAGE) 7 • Use your machine only for laundries that have been specified as suitable for washing by the manufacturer. • Before operating the washing machine, remove the 4 transportation screws and rubber spacers from the back of the machine. If the screws are not removed, it may cause heavy vibration, noise and product malfunction, (voiding the guarantee). • Your machine is not covered under warranty for faults caused by any kind of external factors (pesticides, fire, etc. ). [. . . ] • Push the door of your machine until hearing the locking sound to close it. • Close the door of your machine properly, otherwise your machine will not start the washing operation. click CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING (ADDING DETERGENT INTO MACHINE) 41 The amount of detergent you will put in your machine will depend on the following criteria: • Your detergent utilization will be based on the degree of contamination of your laundries. Do not prewash your less stained laundries and put your slight amount of detergent in the 2nd compartment of the detergent drawer. • For your much stained laundries, select a programme including prewashing, and put ¼ of the detergent you will put in the detergent drawer in the 1st compartment of the detergent drawer while putting the remaining ¾ of it into 2nd compartment. • Use detergents produced for automatic washing machine in your machine. The amount of detergent you will use for your laundries is printed on the detergent package. • The higher the degree of hardness of the water the more detergent you will use. • The amount of the detergent you will use will increase as the amount of your laundries increase. • Put the softener in the softener compartment in the detergent drawer. • Softeners with high density are required to be thinned to a degree before being put in the drawer. If you switch your machine to the standby mode, the Start/Standby led on the electronic display will blink. Inicio Pausa Temp. Centrifugado Diferido Prelavado Inicio Pausa (*)Model Dependant CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING (CHILD LOCK) 51 To avoid programme flow from being affected if programme buttons are pressed or programme button is turned when performing washing operation in your machine, child lock is available. Child lock will be activated in case pressed on both auxiliary functions 3 and 4 at the same time for more than 3 seconds. Diferido Prelavado Temp. Centrifugado Diferido Prelavado Inicio Pausa ‘’CL’’ symbol will flash on the electronic display when activated. If pressed any button while child lock is active, the “CL” symbol will blink on the electronic display. If while the child lock is engaged and any programme is running, the programme knob is switched to the stop position and another programme is selected, the programme previously selected continues from where it left. To deactivate it, it will be sufficient to press on the same buttons for more than 3 seconds. When the child lock is deactivated, the “CL” symbol on the electronic display will go off. CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING (CANCELLING PROGRAMME) 52 If you want to cancel any programme running: 1- Switch the programme knob to “Stop” position. 2- Your machine will stop the washing operation and the programme will be cancelled. 3- To get rid of the water accumulated in the machine switch the programme knob to any programme. 4- Your machine will perform the necessary discharge operation and cancel the programme. 5- You can run your machine by selecting a new programme. CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING FINISHING PROGRAMME 53 Your machine will stop by itself as soon as the programme you have selected finishes. - The expression of “END” will flash on the electronic display. Temp. Centrifugado Diferido Anti Inicio alérgico Paus a - You can open the machine’s door and remove the laundry. [. . . ] Unplug the machine, turn off your faucet and contact the nearest authorised service. (*) E02 The water pressure or the water level inside the machine is low. E03 The pump is faulty or pump filter is clogged or electrical connection of the pump is faulty. Your machine has excessive amount of water. E04 Your machine will discharge water by itself. Pursuant to discharging operation, turn off your machine and unplug it. [. . . ]