User manual SMEG ST8649U MANUALE D'INSTALLAZIONE

[. . . ] DISHWASHER INSTALLATION INSTRUCTIONS CONTENTS Contents 1 2 3 3. 1 4 5 5. 1 5. 2 5. 2. 1 5. 2. 1. 1 5. 2. 1. 2 5. 2. 2 5. 3 5. 3. 1 5. 3. 2 5. 3. 3 5. 4 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 INSTALLATION MATERIAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Kit supplied with dishwasher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 3-02 * The adhesive protection is suitable for kitchens with worktops that do not allow the steel protection to be fixed with screws (e. g. :+ marble or masonry), but it can be also fixed used with other materials. 9 EN 4 INSTALLATION INSTRUCTION DIMENSIONS OF DISHWASHER (See fig. 4-01) A (height) 82 cm - 89 cm 32-9/32” - 35-3/64” B (width) 59. 7 cm ÷ 59, 9 cm 23-1/2” ÷ 23-37/64” C (depth) 55 cm 21-21/32” Tab. 4-01 10 INSTALLATION INSTRUCTION 5 INSTALLATION AND HOOK-UP DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF ON THE SHARP EDGES OF THE APPLIANCE. The sides and rear of the appliance can lie against kitchen units or walls. If the dishwasher is installed next to a heat source, separate it with a heat insulating panel in order to prevent overheating and malfunctions. To assure stability, only install built-in appliances under continuous worktops, securing them to the adjacent kitchen units or worktop with screws. BUILDING-IN A DISHWASHER UNDERNEATH A CERAMIC HOB IS ABSOLUTELY FORBIDDEN. A DISHWASHER CAN BE BUILT-IN UNDERNEATH A CONVENTIONAL HOB PROVIDED THERE IS NO BREAK IN THE KITCHEN WORKTOP, AND THE DISHWASHER AND HOB ARE INSTALLED AND SECURED CORRECTLY, SO THAT NO HAZARDS ARE GENERATED. MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY INSTALLED AND GROUNDED BY A QUALIFIED FITTER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO GROUND THE APPLIANCE OR FROM A DEFECTIVE GROUND CONNECTION. BEFORE PROCEEDING WITH INSTALLATION, DISCONNECT THE MAINS POWER SUPPLY FROM THE WORK AREA. Only for free-standing models • It is strictly forbidden to mount a hob over a free-standing dishwasher. EN 11 EN INSTALLATION INSTRUCTION • If the appliance is not in a niche and can therefore be accessed on one side, cover the door hinge area for safety reasons (cutting hazard). Covers are available as accessories from specialized retailers or from the Technical Service Centre. • To build in the dishwasher, purchase the relative kit from specialized retailers or from the Technical Service Centre. 5. 1 Leveling 5. 1. 2 Levelling the appliance Level the appliance using the relative adjustable feet (e. g. : ref. 5-01); use an open-ended wrench to rotate the feet until the dishwasher is perfectly level. Some models are fitted with just one rear foot which can be adjusted with a screw located at the bottom front of the appliance (ref. 5-02); use a suitable Phillips screwdriver or 8 mm hex head bushing to turn the screw until the dishwasher is perfectly level. Make sure to leave a gap of at least 3 mm (7/64”) between the top of the dishwasher and the worktop (ref. 5-02 5. 2 Connections Install the dishwasher so as to allow ease of access to the electrical and hydraulic connections through the adjacent unit. Tighten the ring nut after pointing the hoses in the required direction. Figure 5-03 indicates the distances to maintain between the dishwasher and the various connections. A rubber hose connected to a sink spray may burst if installed on the same pipes feeding the dishwasher. [. . . ] This guard protects the worktop from steam and condensation when the door of the dishwasher is opened at the end of the washing cycle. Fig. 5-16 Push the dishwasher into position, taking care not to twist or crush the power cord or hoses (see fig. TWO PEOPLE WEARING SAFETY GLOVES ARE NEEDED TO PUSH THE DISHWASHER INTO PLACE. Fig. 5-17 24 INSTALLATION INSTRUCTION 5. 3. 2 Procedure for mounting the door panel EN Mount the door panel. [. . . ]