User manual SMEG WT110.2

[. . . ] Rinse with clean water and dry thoroughly (see cleaning instructions). If the appliance has been stored in cold surroundings (colder than +5 °C), it must be allowed to stabilise for at least an hour before being switched on. If the appliance has been stood on end during transport, it must be allowed to stabilise in normal position for approx. 12 hours before being switched on. 3 GB Get to know your chest freezer Handle Lamp Sealing strip Nameplate Partition/defrost water tray Basket Frezing compartment Ventalation grille Mechanical control panel Defrost water drain Foot CONTROL SUPER MIN MAX fig. [. . . ] If the mains lead has been damaged, it must be replaced with a corresponding type supplied by the manufacturer or an approved service centre. 6 GB Operation and function -18 fig. 4 Mechanical controls In addition to a thermostat knob, the control panel contains two control lamps and a button (fig. The yellow lamp is lit when the Super Freeze button has been pressed (see Super Freeze). Super Freeze If more than 3 kg of fresh items are to be frozen, proceed as follows: 1. The freezer then operates at maximum capacity (the compressor runs continuously). Activate Super Freeze 24 hours before placing fresh items in the freezer. After placing fresh items in the freezer, leave Super Freeze on for a further 24 hours. Then press the Super Freeze button again (the yellow lamp goes off). Starting up Connect the appliance to the socket outlet. The red lamp on the control panel will also light up to indicate that the temperature inside the freezer is not yet sufficiently low. Acoustic alarm Temperature setting The temperature is set by turning the thermostat knob from MIN to MAX. The more the thermostat knob is turned towards MAX, the lower the temperature. To test whether the setting is correct, measure the temperature of the uppermost item in the centre of the freezer. It must be no warmer than ­18 °C. When plugging in the unit an acoustic alarm will activate. When the layer of frost and ice exceeds 4-5 mm the freezer should be completely defrosted. It is recommended that defrosting be performed when there are no or only a few items stored in the freezer. ­25 °C, thus prolonging the length of time they remain frozen after having been removed from the freezer (see step 3 below). Place them in a refrigerator or wrap them up to keep them as cold as possible. Place a bowl of hot (but not boiling) water in the freezer, close the lid and wait approx. To prevent water from damaging the floor during defrosting, it is advisable to check the defrost water tray from time to time and to cover the floor around the defrost water drain to protect against ice and splashes. When all the frost and ice have melted, clean the inside of the cabinet using water with a mild, perfume-free detergent. If many items are to be returned to the freezer, activate the Super Freeze button. 6 9 GB Cleaning and maintenance Cleaning Before cleaning, disconnect the power supply and remove all loose fittings. The sealing strip around the lid must be cleaned regularly to prevent discolouration and prolong service life. After cleaning the sealing strip, check that it continues to provide a tight seal. [. . . ] Reposition items inside the freezer and check that the lid closes tightly. Ventilate the room more often or move the freezer to a room with lower humidity. Wait 2-3 minutes until the underpressure has been equalised and try again. The rating plate contains various technical information, including type and serial numbers. Product number. 12 GB Disposal Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. [. . . ]