User manual STRONG SRT 5222

[. . . ] Strong has supplied this product with the most recent innovations of software and hardware. Strong reserves the right to make changes in production to the software used by your satellite receiver without prior notification. 3 PART 1 · English 1. 1 Safety Instructions: Warning: DO NOT INSTALL YOUR RECEIVER In a closed or poorly ventilated cabinet; Directly on top of or under any another equipment; On a surface which might obstruct the ventilation slots. DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES: To direct sunlight or near any other equipment that generates heat; To rain or intense moisture. To any shock which may cause permanent damage to your receiver; To any magnetic objects, such as loudspeakers, transformers, etc. ; To intense vibration. It is dangerous to touch the inside of the receiver due to high voltage currents and possible electrical hazards. [. . . ] "Power On": The receiver powers on at the designated date and time. "Power Off": The receiver powers off at the designated date and time. "Time interval": The receiver switches on at the designated date and time, displays the channel and then switches off at the designated date and time (The value set at the ending time). Repetition: You can set the cycle of the action designated in the timer mode (one time, Every Day or Every Week). End Time: You can set the ending time of the channel view when the Action mode is on Time Interval. Channel: You can select the channel to be shown when the receiver timer mode Powers ON. Press the Red button to save and proceed with another timer event. 23 PART 1 · English 4. Press the Yellow button to exit the timer menu WITHOUT saving the settings. Tip: You have to select the channel, starting time, and ending time settings if the Action mode is "Time interval". An error message will appear if any of the settings are incorrect. 5. 1. 4 The Installation Menu All settings that are related to TV, Dish, LNB and Satellites are within this menu. The installation menu contains several sub menus such as "System Set-up", "LNB Set-up", "Channel Set-up" and "Parental Lock". Duration: Press OK or the Right button and select how long you want the information banner to be on the screen when starting up your receiver or when changing channels. Select Time Zone: Press OK or the Right button, and a list of the GMT plus or minus the hours you need for your country is displayed. Using UP/DOWN keys select the correct one, and the receiver will automatically show the current time in your country. To set the time manually: Select GMT usage: Press OK or the Right button and use the UP/DOWN buttons to set the GMT usage to "off". The time setting menu will now activate the bottom two fields of the menu. 26 PART 1 · English Adjust Time: Use your Numeric buttons [0-9] to set the local time. Select Set Date: Press OK or the Right button and set the date the way you have set the time. Note: We advise you to use the GMT time settings, if you use the manual time settings, the time will be lost after the unit has been disconnected from the mainpower. Power on Channel: This function allows you to set the channel you want when the receiver turns on. Last Channel: The receiver will start-up with the channel that you viewed before turning the receiver off. Defined Channel: This function allows you to set the channel you want when the receiver turns on. [. . . ] EPG shows the event information on the current TP channel by time zone. AUDIO Shows the list of available audio languages for the channel you are watching. You can change the audio language you want to hear by using the Up/Down keys, and pressing the OK button. In addition it sets the current channel audio to stereo ((o)), left-mono ((o or right-mono o)). [. . . ]